Picket Line

Details and Minor Assembly Instructions

After viewing the picture, you will see that the fences are attached by extending our bungee-ball over to the neighboring fence. locking it into a provided slot. You can then re-cover the post cap for a finished look. (The bungee is provided on only one end.)

Also pictured is a representation of our swivel foot.

Metal wickets are also provided for a more secure set-up on turf or dirt. Ask about the wickets. 

For shipping reasons, our fences are sent with the feet detached. It is a simple process to attach the feet.

1. The ½" round metal standoff has been put in place and must be temporarily removed. It is a tight fit and should remain that way.
2. Each foot comes with the eyebolt attached for easy placement on the post.
3. Place the eye of the bolt through the slot on the bottom inside of the post and replace the round standoff.intersecting the eye to, thus, lock it into place. Remember, the standoff will be tight in its hole.
4. Squeeze the standoff totally through, leaving the ends of the standoff flush with the sides of the post.
5. Replace the white nylon screws.
6. You can now tighten the lock nuts until the swivel action of the foot is firm against the bottom of the post.
7. This work will take no more than 2 minutes per fence

[Back to Picket Line]